ATTACHMENT OF THE H-1 WARMING OVEN
TO THE HH005 COOKSTOVE

1.  Align the cast iron warming oven brackets (small end down, holes to the inside) with the edge of the stove top, ensuring that the bracket corners are lined up with the corresponding back corners of the stove top.  It is easier to work with one bracket at a time.

2.  Once the bracket is aligned, mark through the hole (one per bracket) onto the top of the stove using a sharp scribe.  You may have to estimate the center of the hole, but it does not have to be exact.

3.  Remove the bracket(s).

4.  Locate and mark the center of the hole with a sharp center punch to prevent the drill from wandering when drilling.

5.  Use a variable speed drill motor with a 1/4” drill bit.  Drill the holes at a LOW SPEED setting, using light pressure, drill the holes straight through the stove top.

6.  Complete the assembly of the Warming Oven as follows:

• Fasten the brackets to the stove top.

• Install the Warming Oven on the brackets.

• Install the back splash shield between the Stove and the Warming Oven. 

• The lip on the splash shield should be at the bottom facing the front of the stove.

• Install the top piece of the Warming Oven.

7.  Installation should now be complete.

Cast Iron Wood and Coal Stoves Plate Steel Wood Stoves Circulator Wood and Coal Stoves
EPA CERTIFIED WOOD STOVES Add-on Furnaces Barrel Stove Kits Heat Reclaimers
Customer Comments Dealer Information Policies F. A. Q. ALL Stoves Home